Application of microcrystalline cellulose as an efficient and cheap sorbent for the extraction of metoprolol from plasma and wastewater before HPLC–MS/MS determination

A dispersive solid-phase extraction method based on a new sorbent has been performed on plasma and wastewater samples to determine metoprolol by high-performance liquid chromatography–tandem mass spectrometry. In this study, the analyte was adsorbed from the samples onto microcrystalline cellulose as a green and efficient sorbent and then eluted for use in the determination step. In the mass spectrometer, the analyte was detected in the positive mode and selectivity of the analysis was increased by sequential mass analysis through multiple reaction monitoring. All of the effective parameters in the extraction of metoprolol from plasma and wastewater were optimized. Under optimal conditions the method was linear in the ranges of 1–1,000 and 0.1–1,000 ng/ml in plasma and wastewater samples, respectively. The detection limits of the method were 0.30 and 0.03 ng/ml in plasma and wastewater samples, respectively. The data showed that the method provides low detection limit, wide linear range, good precision and high extraction recovery. Finally several plasma and wastewater samples were successfully analyzed using the method. The use of a small amount of a green and inexpensive sorbent and a low volume of plasma without the need for further pretreatment steps are the main advantages of the method.     

A sensitive and efficient method for trace analysis of some phenolic compounds using simultaneous derivatization and air‐assisted liquid–liquid microextraction from human urine and plasma samples followed by gas chromatography–nitrogen phosphorous detection

In present study, a simultaneous derivatization and air‐assisted liquid–liquid microextraction method combined with gas chromatography–nitrogen phosphorous detection has been developed for the determination of some phenolic compounds in biological samples. The analytes are derivatized and extracted simultaneously by a fast reaction with 1‐flouro‐2,4‐dinitrobenzene under mild conditions. Under optimal conditions low limits of detection in the range of 0.05–0.34 ng mL^?1 are achievable. The obtained extraction recoveries are between 84 and 97% and the relative standard deviations are less than 7.2% for intraday (n = 6) and interday (n = 4) precisions. The proposed method was demonstrated to be a simple and efficient method for the analysis of phenols in biological samples. Copyright © 2015 John Wiley & Sons, Ltd.     

Hierarchical motion planning at the acceleration level based on task priority matrix for space robot

Nonlinear Dynamics - A capacitive micromachined ultrasonic transducer (CMUT) due to many benefits is being considered as an imaging and therapeutic technology recently. The critical challenge is to...     

Incorporation of silica nanoparticles and polyurethane into hybrid composites for increase of char residue

Journal of Thermal Analysis and Calorimetry - Effect of different chain extenders, silica nanoparticle loading, and using sol–gel method on the thermal properties of polyurethane (PU) hybrid...     

Super-pressed and super-cooled (?) P(EO)20LiBETI

High pressure conductivity measurements have been carried out on P(EO)₂₀LiBETI from 295 K to 368 K. The decrease of electrical conductivity with pressure is larger in the partially crystalline phase (low temperature and low pressure or high temperature and high pressure) than in the fully amorphous phase (high temperature and low pressure). It is found that if the phase transition is approached from the crystalline phase (decreasing pressure), the pressure of the phase transition varies from 0 to 0.23 GPa as the temperature increases from 336 K to 358 K. The shift of the phase transition temperature with pressure is approximately the same as the shift of the glass transition temperature with pressure for pure PEO. This can be understood in terms of the defect diffusion model. If the material is above 336 K and is in the fully amorphous phase, after pressure is increased above the critical pressure, the material remains in the amorphous phase for extended periods of time before transforming to the partially crystalline phase. This is reminiscent of a super-pressed state but may be an indication of slow crystallization kinetics.     

Pentadiagonal Oscillatory Matrices with Two Spectrum in Common

We denote the spectrum of an square matrix A by σ(A), and that of the matrix obtained by deleting the first i rows and columns of A by σ_i(A). It is known that a symmetric pentadiagonal oscillatory (SPO) matrix may be constructed from σ, σ₁ and σ₂. The pairs σ, σ₁ and σ₁, σ₂ must interlace; the construction is not unique; and the conditions on the data which ensure that A is oscillatory are extremely complicated. Given one SPO matrix A, the paper shows that operations may be applied to A to construct a family of such matrices with σ and σ₁ in common. Moreover, given one totally positive (TP) matrix A, we construct a family of TP matrices with σ, σ₁ and σ₂ in common.     

Preparation and characterization of AgI nanoparticles with controlled size,morphology and crystal structure

AgI nanoparticles were prepared by solution-based routes using water-soluble anionic or cationic polyelectrolytes as capping agents. Depending on the polyelectrolytes, AgI nanoparticles with well-defined morphology, size, and phase compositions were obtained: the use of poly(sodium 4-styrenesulfonate) (PSS) resulted in AgI nano-rods of β-AgI in wurtzite structure (2H); with poly(acrylic acid sodium salt) (PAS) truncated-tetrahedron shaped γ-AgI nanoparticles (nanotetrahedra) in zinc-blende structure (3C) were obtained; by employing poly(diallyldimethylammonium chloride) (PDADMAC) plate-like AgI nanoparticles (nano-plates) consisting of unusual polytype phases of AgI (7H and 9R) were formed. Macroscopically unstable γ-AgI and 7H and 9R phases could be stabilized in the form of nanocrystalline powders. They transform reversibly into the high temperature α-AgI phase and exhibit unusually high ionic conductivity and substantially smaller transformation enthalpy values compared to the macroscopic β-AgI.     

Optimizing a linear function over an integer efficient set

In this paper, a method for optimizing a linear function over the integer Pareto-optimal set without having to determine all integer efficient solutions is presented. The proposed algorithm is based on a simple selection technique that improves the linear objective value at each iteration. Two types of cuts are performed successively until the optimal value is obtained and the current truncated region contains no integer feasible solution.     

Sensitive and simple cloud-point preconcentration atomic absorption spectrometry: application to the determination of cobalt in urine samples.

A new approach for developing a cloud-point extraction-flame atomic absorption spectrometric method has been described and used for the determination of cobalt. In this approach, water was removed from the final diluted surfactant rich phase obtained in cloud-point extraction procedure. The results indicated that removing water from this phase increased the enhancement factor by 4-fold. 1-(2-Pyridylazo)-2-naphthol (PAN) and octylphenoxypolyethoxyethanol (Triton X-114) were used as a hydrophobic ligand and a nonionic surfactant, respectively. The chemical variables affecting the preconcentration step were optimized. The effect of the water concentration in the final diluted methanolic surfactant solution on the analytical signal was investigated. The results showed that the analytical signal decreased by 30% and 52% in 15% and 25% water concentrations in methanol, respectively. An enhancement factor of 115 was obtained for cobalt extracted from only 10 ml of a sample. The detection limit obtained under the optimal condition was 0.38 microg l(-1). The proposed procedure was applied to the determination of cobalt in urine samples.